Installing TruCarbon’s Carbon Fiber GT500 Style Rear Wing

If you’re looking for the ultimate in carbon fiber body accessories look no further than TruCarbon. TruFiber’s carbon fiber division is well known for making hoods, diffusers & other high quality carbon parts for the new Mustangs. We decided to install their GT500 style rear trunk wing on our project 2013 5.0 to match our carbon hood vents. The isntall was very straightforward & took about an hour using only a flat head screwdriver, a dremel, double sided tape & a 10mm socket.

Start by opening the trunk and removing the push pins holding the inner carpet liner tot he trunk lid.

IMG_1163

Once the inner liner is removed locate the two 10mm nuts on either side of the trunk lid holding the factory wing in place. Remove all four bolts (2 on each side) and set them aside, they will be re-used to fasten the new carbon wing.

IMG_1164

After removing the four bolts the next and most difficult step is removing the double sided tape from under the factory wing. The best way to loosen the adhesive is to use a heat gun & fishing line. Be careful with the factory wing when removing it, it’s made of brittle plastic and will break if pulled too hard. Take your time with this step. Once you get a foot or two up on one side the rest gets easier.

IMG_1166

Once the factory wing is removed clean off the old adhesive & make sure all surfaces are clean before installing the new double sided tape. We opted to use very little tape as the four bolts do a good enough job of holding the wing in place. Use just enough tape to keep the carbon wing from rubbing on the paint.

IMG_1169

We needed to widen one hole slightly to make the studs line up for the carbon wing. Being a hand made part every wing will be slightly different but other than this one small fix the part’s fitment is absolutely spot-on. We used a small dremel bit to make the one hole a few millimeters wider.

IMG_1170

Once the wing is in place, tighten the four nuts holding the wing to the trunk lid and you’re finished! The last finishing detail is the wing lip that fastens using double sided tape. Remove the protective backing from the adhesive and stick the lip in place.

IMG_1171

IMG_1175

You can find all of our TruCarbon body components for 10-13 Mustangs on StangMods.com by clicking the following link – http://www.stangmods.com/Trucarbon-Mustang-Carbon-Fiber-s/688.htm.

Here are some images of the finished product

tru-carbon-mustang-gt500-wing

gt500-wing-stangmods

carbon-fiber-gt500-wing

tru-carbon-gt500-wing

tru-carbon-mustang-wing

gt500-wing-carbon-fiber

The same GT500 wing can be found on StangMods through this link: http://www.stangmods.com/TruCarbon-DCA42KR-Carbon-Fiber-GT500-Style-Wing-p/2780.htm

2005-2009 Mustang owners click here: http://www.stangmods.com/TruCarbon-Carbon-Fiber-GT500-Wing-p/2885.htm

About these ads

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out / Change )

Twitter picture

You are commenting using your Twitter account. Log Out / Change )

Facebook photo

You are commenting using your Facebook account. Log Out / Change )

Google+ photo

You are commenting using your Google+ account. Log Out / Change )

Connecting to %s