In this edition of writeups, we go over the installation process of adding front turn signals to your 2005-2009 Mustang. Installation can be done without even lifting the car in the air.
- Tools Required:
If you begin with the driver’s side, you’ll want to turn the wheel all the way over to the passenger side to gain access to the screws holding the inner fenderwell on. Remove them using a phillips head screwdriver along with the one push pin.
Once all three screws are removed, you can peel back the inner fenderwell and gain access to the turn signal lens behind the bumper cover. Now you’ll work on removing the stock turn signal lens. There are two white pins holding the turn signal to the bumper cover. Squeeze one pin at a time and gently pull the lens away to release it from the bumper.
Now, you’ll want to remove the stock bulbs from the turn signal lens before completely removing it from the vehicle. There are two separate bulbs in the lens. (3157 and 194 bulb) Grasp each bulb and turn it counter-clockwise to free it from the housing. The lens should be free now. Remove it from underneath the bumper. It helps to have an extra set of hands here
We are now ready to re-install the new turn signal lens. You first want to find the tab behind the bumper cover. This will help you guide the new turn signal lens into place. The tab is shown below.
Slide the new lens in through the opening in the fenderwell. Align the tab on the new lens with the slot on the bumper cover as shown below.
Secure the other end of the lens with the white pins as shown below.
One of the last steps is to install the new 3157 and 194 Chrome-Amber Bulbs. Using latex gloves, remove the stock bulbs and re-install the chrome amber ones. Then place them in the housing and turn them clock wise to secure them in the new lens. It is important to not touch the glass portion of the bulb with your exposed fingers. The oils from your skin can prematurely wear out the bulb. Once your bulbs are in, turn on your turn signals to ensure they work.
Finally, re-install the inner fenderwell screws to complete your installation. Now you can enjoy the clear look while staying DOT legal. The different turn signal lens and bulb packages can be found on our site here: http://www.stangmods.com/Mustang-Clear-Turn-Signal-Lenses-Side-Markers-s/157.htm