Installing StangMods 99-04 Vinyl Tail Light Decals

Mustang Tail Light Decal Installation (Flamed, Outline & Honeycomb Kits)

Tools Required:

  • Squeeggee
  • Spray bottle
  • Liquid soap
  • Terry cloth or towel

Use rubbing alcohol to wash all dirt and road grime from the surface of your tail lights.

Mix your soapy water solution by adding a few drops of liquid soap to warm water in a spray bottle.

Generously spray the solution over the lens you are working on. Then remove the vinyl decal from the paper backing and apply it to the lens.

While the solution is still saturating the tail light lens, align the decal for a correct fitment and use your squeeggee to remove any excess solution from underneath the decal. Start from the center and move your way out.

Wait a few minutes, depending on the temperature, and then try to remove the transfer tape (top protective paper) from the vinyl. If the paper comes off and the vinyl stays in place, then you are good to go and you can move on to the next one. If the vinyl comes off, rather than staying on the car then use your squeege to apply the decal over the lens again.

Finish up by wiping off any excess solution from the body of your Stang.

Visit StangMods for more Mustang vinyl decals

Author: stangmods

73 stories / Browse all stories

Related Stories »

Leave a Reply

Your email address will not be published. Required fields are marked *

You may use these HTML tags and attributes: <a href="" title=""> <abbr title=""> <acronym title=""> <b> <blockquote cite=""> <cite> <code> <del datetime=""> <em> <i> <q cite=""> <strike> <strong>

StangMods Instagram Feed »