Our latest write-up goes over the process of installing a Mach 1 style chin spoiler on a 1999-2004 Mustang. StangMods carries high quality ABS plastic Mach 1 style lip spoilers with an OEM style textured finish. Not the glossy finish many aftermarket companies sell. Each of our chin spoiler kits comes included with push pin fasteners for a tight fit. This chin spoiler will give the front of your 99-04 Mustang a clean yet sporty look. You can find our chin spoilers for 99-04 here – http://www.stangmods.com/Mustang-Chin-Spoiler-for-99-04-p/00084.htm and the same chin spoiler for 96-98 Mustangs here – http://www.stangmods.com/Mustang-Chin-Spoiler-for-94-98-Mustangs-p/00542.htm
- Duct Tape
- Push Pin Fasteners
- 1/4″ Drill Bit
First start off by securing the vehicle on a level surface. Make sure the car is in gear and the parking brake is engaged.
Raise the front of the car so that you may have adequate space to work underneath the front bumper.
Mock fit the chin spoiler to the front bumper. It is easier if two people are handling the chin spoiler.
When you get the spoiler positioned to your liking, use duct tape to secure it to the bumper. (Tape will be removed later)
Drill ¼” holes into the bottom of the front bumper at each Chin Spoiler screw location.
Finally, insert pushpin fasteners into the holes on the bumper to secure the chin spoiler.
The last step is to remove the duct tape you used earlier to secure the chin spoiler to the bumper.
This completes the installation process.