In this write-up we will go over the simple installation of TruCarbon’s carbon fiber steering wheel trim. -Click Here To View In Our Store- The only tools you’ll need for this install are a deep 8mm socket & a flathead. Start by removing the two plastic covers on either side of the back of the steering wheel right before the steering column. A flathead screwdriver is the best way to pry out those covers. Under the covers you will see an 8mm bolt on either side. Remove both of these bolts and pull the airbag section from the wheel.
Once you’ve pulled the center of the wheel out, remove the two wires by squeezing the clips holding them to the airbag.
After the airbag is free from the steering wheel pull the first trim piece off of the wheel. use a flathead or your nails to pull toward you, the trim pieces are held in by four posts.
Once the trim piece is free, unclip the buttons from the trim and insert them into the new carbon wheel spoke. Repeat the last steps for the other spoke & buttons.
For the lower wheel spoke you’ll need a flathead to pry it off, be gentle & take your time.
Reinstall the lower trim piece, the airbag, bolts, etc & you are done!